You can use the gooseneck with clamps to attach accessories that can be connected to studio pins 5/8 "or thread 1/4" or reduced to 3/8 ". It can be used to attach lights, microphones and more. ... Read More
The 50 cm gooseneck is terminated on one side with a clamp, on the other side with a 5/8 "studio pin with a 1/4" thread.
- Clamp and studio pin (spigot) connected by a flexible steel neck
- The load capacity of the neck is 200-400 g depending on the bending angle
- Suitable for smaller and lighter accessories
The goose neck is equipped with one clamp with flat jaws with a very strong spring and one clamp adapted for anchoring to pipes up to a diameter of 35 mm or a flat surface up to a thickness of 30 mm by means of a screw. The gooseneck has a diameter of 13 mm and its load capacity depends on the unloading of the entire set of approx. 200-400 g according to the unloading of the arm.
Flat clamp 80 mm
Clamp with rubber collet guards 80 mm wide, which prevents scratches or damage. The pattern on the rubber ensures a firm anchoring on the plates or pipes securely up to a diameter of approx. 30 mm. The collets can be opened to a maximum of 50 mm.
The clip has a very strong grip and, thanks to its solid construction, does not deform during handling.
Clamp material: steel
Collet width: 80 mm
Full extension of collets: 50 mm
Studio pin
Clamp for fastening to pipes up to 35 mm in diameter or flat surfaces up to 30 mm thick by means of a screw.
Pin material: brass
Thread: 1/4 "-20 UNC
Gooseneck length: 48-50 cm
Neck material: steel
Clamp material: Steel, equipped with rubber guards that prevent scratches or damage
Gooseneck diameter: 13 mm
Weight: 475 g