3 points to the loyalty system
Availability
Product is no longer available
Manufacturer
Product code
793780
Package Weight
0.15 kg
The 2.4 GHz remote trigger Studio Trigger ST-1 enables wireless triggering and controlling of the mecastudio SL studio flashes. In this series the matching receiver already built-in. ... Read More
Description
- LEDs for the groups (A. B. C. 0)
- Buttons for the group selection
- Manual release button
- Increasing the performance
- Tap: Light performance is increased in 0.1 stePs
- Keep pressed down: Switching to modelling light by tapping the performance of the modelling light is increased - Reducing the performance
- Tap: Light performance is reduced in 0.1 steps
- Keep pressed down: Switching to modelling light by tapping the performance of the modelling light is reduced - Base connector
- DIP switch in the battery compartment for setting the channel
- Battery compartment with lithium battery CR2032
Assembly/operation
- Switch off the camera and ST-1 before assembly or disassembly.
- Turn the knurled nut fully against the ST-1 .
The locking pin in the base connector is now fully inserted into the trigger housing. - Slide the Studio Trigger with the base connector to the stop in the accessory shoe on the camera.
- Turn the knurled screw against the camera body until it clicks into place and clamp the ST-1.
On camera bodies without a locking hole, the spring-mounted locking pin sinks into the housing of the Studio Trigger, as a result the surface is not damaged.
For disassembly, proceed in the reverse order.
Observe the safety instructions before start-up, Switch off the Studio Trigger before assembly or disassembly.